【概述】當溫濕度控制器運轉后,濕度實際值一直無法到達設定值,且濕度實際值低于濕度設定值很多

 After temperature humidity controller starting, humidity actual value till can’t reach the setting value and lower than the setting value.

檢查步驟: Check steps

1、查看是否濕度部份的固態繼電器燒毀斷路: 如果加熱器未燒毀,使用用電表交流電壓檔,電壓檔位開到600伏特的位置,將紅黑棒分別放在線號標注為H的那一顆固態繼電器交流兩側,將溫度部份的濕度設定值設置100%,此時濕度部份的固態繼電器的指示燈會亮起,如果量測的電壓值沒有變化,維持在220V或者380V,則代表固態繼電器燒毀呈現斷路狀態。

Check if the humidity of solid state relay burned and turn off circuit: If heater is not burning, use in AC voltage meter gears, gear drive voltage to 600 volts, will be red and black on the annotation of line number for H that a solid state relay communication on both sides, set the temperature of humidity value to 100%, humidity at this time of solid state relay will flashing lights, if the measured voltage value did not change, maintained at 220V or 380V, represents solid state relay burned show breaker state.

2、查看保險絲是否燒毀; Check if the fuse burns.

3、查看是否加濕桶加熱器燒毀:將加濕桶加熱器兩條線剪斷,使用三用電表歐姆檔,量取電阻值,如果電阻呈現無限大,代表加熱器燒毀。 

Check if humidifying barrel and heater burn: cut off the two of the humidifying barrel and heater, use the three-meter ohmmeter and measure the resistance, if the resistance appears to be infinite, it means the heater will be burnt out.

解決辦法: Solutions

1、更換濕度部份的固態繼電器(線號標注為H的那一顆固態繼電),或者通知售后上門進行維修; 

Replace the solid state relay of the humidity part (the one marked with the line number of H), or notify the after-sales staff to conduct on-site maintenance.

2、更換同規格保險絲; Replace fuses of the same specification.

3、通知加濕桶加熱器的商家, 或者通知售后上門進行維修。

Notify the business of the humidification barrel and heater, or notify the after-sales service for on-site maintenance.